高压探头KHT1000C和KHT6000D校准发生器用于高压探头和分压器的射频和直流校准，KHT6000C型号仅用于射频校准。

除了通过前面板控件进行手动操作外，校准发生器还可以通过可选的远程控制单元进行操作，或者通过USB进行远程操作，并通过GPIB接口进行可选操作。远程操作时，如果需要，可以设置方波电压、脉冲宽度、重复频率（可为单脉冲）和直流输出电压。

KHT 6000 型号可选配联锁控制线 （2 m），用于连接闭合触点（防护罩）。通过仪器背面的 LEMO 推挽式连接器与仪器进行连接。KHT 6000 型号可产生高达 6000V 的正陡沿输出电压。KHT 1000D 可产生高达 ±1000V 的直流电压和陡峭方波电压。输出电压可以是正的，也可以是负的，因此可以在不更换探头的情况下测试两个极性。下降边缘和上升边缘的边缘陡度相同。输出电压可在四个范围内切换，以数字方式显示。输出电压可以完全校准，因此符合 ISO 9000 ff 对无缝测试设备监控的要求：具有低上升和下降时间和低过冲，甚至可以评估、调整和校准快速高压分压器。

The calibration generators for high voltage probes KHT1000C and KHT6000D are used for RF and DC calibration of high voltage probes and dividers, the KHT6000C models for RF calibration only.

In addition to manual operation via the front panel controls, the calibration generators can be operated via the optional remote control unit, or remotely via USB and optional via GPIB interface. When operating remotely, square wave voltage, pulse width, repetition frequency (single pulses possible) and DC output voltage can be set if required.

The KHT 6000 models can optionally be equipped with an interlock control line (2 m) for connection to a closing contact (protective hood). The connection to the instrument is made via a LEMO push-pull connector on the rear of the instrument. The KHT 6000 models generate positive steep-edge output voltages up to 6000V. The KHT 1000D generates DC voltages and steep-edged square-wave voltages up to ±1000V. The output voltage can be either positive or negative, so that both polarities can be tested without changing the probe. The edge steepness is identical for falling and rising edges. The output voltage, which can be switched over in four ranges, is displayed digitally. The output voltage can be fully calibrated and thus meets the requirements of ISO 9000 ff for seamless test equipment monitoring: With low rise and fall times and low overshoot, even fast high-voltage dividers can be evaluated, adjusted and calibrated.